Lubricating Your Airsoft Gun

Like with firearm maintenance, airsoft pistols too need some TLC from time to time, and the purpose of this web site is to educate you – typically the airsoft enthusiast – concerning when and how this upkeep should occur. First, to see a common misconception… airsoft prints are NOT to be lubricated together with WD-40 or gun olive oil. The proper lubricant for paintball guns is high grade plastic oil. (I personally make use of Premium P-Force airsoft silicon performance lubricant in a squirt bottle). Anything else will attract allergens and dirt, foul your personal barrel and internals, in addition to cause corrosive damage to your own airsoft gun. Use plastic oil spray exclusively.

Paintball gun barrels do once in a while need to be cleaned, and the of ‘as to when’ lies in the flight-path of your respective airsoft gun BBs. In the event the airsoft pellet is deviating vertically, then it’s time and energy to retrieve your cleaning rods and a small piece of top quality paper towel which you’ll twine through the tip of the fishing rod (as you would thread by way of a needle – the deprive of the paper towel must be approximately ½” wide. Carefully spray the strip, then insert the cleaning fly fishing rod strip-first into the barrel, re-writing the rod as you carefully move it first lower the length of the barrel, and back out. Following this, thread any clean strip of document towel into the tip with the cleaning rod and do it again the procedure (this will get rid of any excess silicon oil from your barrel, and leave it obstruction-free).

For issues with airsoft AEGS mis-feeding or jamming, at times an airsoft guns tore up needs to be lubricated. To achieve this, remove the gun’s magazine as well as fire two to three times inside semi-auto to assure that the jump up is free of archery BBs, and then place the pistol on your lap, upside down. Along with your bottle of silicon acrylic, angle the bottle and also accompanying spray tube (which you’ve already inserted to the bottle’s nozzle) into the get up, and spray one or two times. Be sparing with all the oil (you don’t use too much), and let the weapon sit for five minutes, enabling the silicone to drain into the hop up.

Just as with the hop up, your current gearbox may occasionally must be lubricated as well (although considering that gearboxes comes from their individual manufacturers packed with industrial-grade fat or white lithium, this sort of maintenance rarely needs to be conducted. If your gearbox is whimpering, this may however do the trick). To lubricate the gear-box, the motor will 1st need to be removed from the paintball electric gun, and once that will task is completed, a tiny hole in the bottom from the gearbox will be visible by means of peering into the now-hollow firearm handle. Place the tip in the spray tube through the deal with and just into the visible gear-box hole, and spray 3 to 4 times. Again, leave often the AEG upside-down so as to permit the silicon oil to work it is way into the airsoft gear-box.

Leave a Reply

Your email address will not be published. Required fields are marked *